Skrab

The M16 x 1.5 machine-manual tap is used to calibrate and create threads in blind and through holes on the machine in a single pass. The recommended hole diameter is 14.5 mm...

A set of two M22 x 2.5 taps is used for manual calibration and threading of blind and through-hole taps using a special holder. The recommended bore diameter is 19.5 mm. The first tap, rough, has cut tooth tips, the outer diameter is smaller. The second, finishing, with short tooth segments, has elo..

The M4 x 0.7 machine-manual tap is used to calibrate and create threads in blind and through holes on the machine in one pass. The recommended hole diameter is 3.3 mm...

A set of two M4 x 0.75 taps is used for manual calibration and threading of blind and through-hole taps using a special holder. The recommended bore diameter is 3.3 mm. The first tap, rough, has cut tooth tips, the outer diameter is smaller. The second, finishing, with short tooth segments, has elon..

A set of two M4 x 0.75 taps is used for manual calibration and threading of blind and through-hole taps using a special holder. The recommended bore diameter is 3.3 mm. The first tap, rough, has cut tooth tips, the outer diameter is smaller. The second, finishing, with short tooth segments, has elon..

A set of two M5 x 0.8 taps is used for manual calibration and threading of blind and through-hole taps using a special holder. The recommended bore diameter is 4.2 mm. The first tap, rough, has cut tooth tips, the outer diameter is smaller. The second, finishing, with short tooth segments, has elong..

The M6 x 1.0 machine-manual tap is used to calibrate and create threads in blind and through holes on the machine in a single pass. The recommended hole diameter is 5.0 mm...

A set of two M6 x 1.0 taps is used for manual calibration and threading of blind and through-hole taps using a special holder. The recommended bore diameter is 5.0 mm. The first tap, rough, has cut tooth tips, the outer diameter is smaller. The second, finishing, with short tooth segments, has elong..

A set of two M8 x 1.25 taps is used for manual calibration and threading of blind and through-hole taps using a special holder. The recommended bore diameter is 6.8 mm. The first tap, rough, has cut tooth tops, the outer diameter is smaller. The second, finishing, with short tooth segments, has elon..

A set of two M8 x 1.0 taps is used for manual calibration and threading of blind and through-hole taps using a special holder. The recommended bore diameter is 7.0 mm. The first tap, rough, has cut tooth tips, the outer diameter is smaller. The second, finishing, with short tooth segments, has elong..

Tap holder, taps M3x0.5, M4x0.7, M5x0.8, M6x1, M8x1.25, M10x1.5, M12x0.75..

Measuring tape measure 10m*25mm with a latch. The length of the tape is 10 m, the width of the tape is 25 mm. The body of the tape measure is made of rubberized impact-resistant plastic, has a dust-repellent coating...