Taps

..

A set of two M8 x 1.25 taps is used for manual calibration and threading of blind and through-hole taps using a special holder. The recommended bore diameter is 6.8 mm. The first tap, rough, has cut tooth tops, the outer diameter is smaller. The second, finishing, with short tooth segments, has elon..

..

..

A set of two M8 x 1.0 taps is used for manual calibration and threading of blind and through-hole taps using a special holder. The recommended bore diameter is 7.0 mm. The first tap, rough, has cut tooth tips, the outer diameter is smaller. The second, finishing, with short tooth segments, has elong..

..

Tap holder, taps M3x0.5, M4x0.7, M5x0.8, M6x1, M8x1.25, M10x1.5, M12x0.75..

..

..

..

..

..