Taps

..

..

The M4 x 0.7 machine-manual tap is used to calibrate and create threads in blind and through holes on the machine in one pass. The recommended hole diameter is 3.3 mm...

..

A set of two M4 x 0.75 taps is used for manual calibration and threading of blind and through-hole taps using a special holder. The recommended bore diameter is 3.3 mm. The first tap, rough, has cut tooth tips, the outer diameter is smaller. The second, finishing, with short tooth segments, has elon..

..

A set of two M4 x 0.75 taps is used for manual calibration and threading of blind and through-hole taps using a special holder. The recommended bore diameter is 3.3 mm. The first tap, rough, has cut tooth tips, the outer diameter is smaller. The second, finishing, with short tooth segments, has elon..

..

A set of two M5 x 0.8 taps is used for manual calibration and threading of blind and through-hole taps using a special holder. The recommended bore diameter is 4.2 mm. The first tap, rough, has cut tooth tips, the outer diameter is smaller. The second, finishing, with short tooth segments, has elong..

..

The M6 x 1.0 machine-manual tap is used to calibrate and create threads in blind and through holes on the machine in a single pass. The recommended hole diameter is 5.0 mm...

A set of two M6 x 1.0 taps is used for manual calibration and threading of blind and through-hole taps using a special holder. The recommended bore diameter is 5.0 mm. The first tap, rough, has cut tooth tips, the outer diameter is smaller. The second, finishing, with short tooth segments, has elong..